I am trying to draw a fiber section that has the following geometry:
- 10.png (6.41 KiB) Viewed 1338 times
- 9.png (28.36 KiB) Viewed 1338 times
Many thanks for your support !
Fiber section
Fiber section
Hi STKO teams,
I am trying to draw a fiber section that has the following geometry: Is it possible to do it with the rectangular fiber section command ? Because it seems like I must have at least one rebar at each corner.
Many thanks for your support !
I am trying to draw a fiber section that has the following geometry: Is it possible to do it with the rectangular fiber section command ? Because it seems like I must have at least one rebar at each corner.
Many thanks for your support !
Re: Fiber section
The algorithm wants at least 1 corner rebar, but you can make its area equal to 0, so it's like not having them!
Use these settings:
Use these settings:
- 0 corner rebars.png (39.27 KiB) Viewed 1302 times