asdeasoft.net

Hello,

I strive to use the generated STKO files directly for Openseesmp under under "DOS Coomand System", not STKO enviroment.

For this purpose
I copied the all the generated STKO files into the directory "C:\OpenSees-Solvers"
Then, I activated the "DOS Coomand System" . The following outcomes from trials are obtaned.

i)"RUNNING AS SEQUENTIAL":
I can sucesfully run Openseesmp under "DOS Coomand System" with a solely command as "Openseesmp". Then, of Course, it can be defined the further "Opensees commands". This is not problem.

ii)"RUNNING AS PARALLEL":
I can not sucesfully run Openseesmp under "DOS Coomand System" with a command set
as "openseesmp.bat main.tcl 2"

I have an error as:
"RUNNING AS PARALLEL"
0 [main] mpiexec.hydra 8144 cygwin_exception::open_stackdumpfile: Dumping stack trace to mpiexec.hydra.exe.stackdump


iii)"RUNNING AS PARALLEL":
I can not sucesfully run Openseesmp under "DOS Coomand System" without using the ""openseesmp.bat"
as "mpiexec.hydra.exe -n 2 OpenSeesMP.exe main.tcl"

I have an error as:
0 [main] mpiexec.hydra 5672 cygwin_exception::open_stackdumpfile: Dumping stack trace to mpiexec.hydra.exe.stackdump

What must I do to deal with this problem arisen from the use of Openseesmp?

I copied the all the generated STKO files into the directory "C:\OpenSees-Solvers"

First you don't need to copy those files in there (it's bad practice).

• Keep your file in a directory (say C:\Analyses\Analysis1)
• open a command line (cmd)
• go into the analysis directory

  Code: Select all

  cd C:\Analyses\Analysis1

• Run openseesmp with the same number of processors as the number of partitions in STKO mesh (let's say you partitioned it in 3 partitions)

  Code: Select all

  openseesmp.bat main.tcl 3