ERROR IN PARALLEL ANALYIS

[Zeeshanbhat]

Dear Team,

I am currently facing an issue with STKO after not using it for the last 6-7 months. I had been utilizing OpenSeesMP for parallel analysis, and my models were performing well without any problems. However, upon revisiting my models and attempting to analyze them again in STKO, I encountered an error that states: "Can't read process ID - no such variable exists."

PROCESS ID.png (41.7 KiB) Viewed 3545 times

Additionally, I noticed that there have been some additions in the code

STKO1.png (104.42 KiB) Viewed 3545 times

compared to the previous version.

STKO 2.png (36.91 KiB) Viewed 3545 times

The model is attached below:

Modelbi.zip

(251.91 KiB) Downloaded 263 times

I would greatly appreciate any assistance or guidance you could provide to help me resolve this error

Looking forward to your prompt response.

Best regards,
Zeeshan

[Zeeshanbhat]

I have attached the model also. The model was running fine in previous version of STKO. None of my model is working now. Kindly help in this regard.

Regards,
Zeeshan

[Zeeshanbhat]

Gentle Reminder

[STKO Team]

It's because you were running the analysis using a custom Tcl script that was compliant with the old STKO version.

However, now it should be sufficient to replace this line in your last analysis step:

custom_run.png (11.19 KiB) Viewed 3427 times

I couldn't test it because I don't have your input GM, but let me know if it works

[Zeeshanbhat]

Dear Team,
Thank you for your assistance. I have analyzed the revised model with the correction you provided. Unfortunately, it is still displaying the same error.

error.png (97.71 KiB) Viewed 3418 times

I have attached the revised model along with the ground motion file for your reference. I kindly request your assistance in resolving this issue.

Thank you for your continued support.

Regards,
Zeeshan Bhat

[STKO Team]

You have to change also every instance of process_id with STKO_VAR_process_id
here's a modified file:

Modelbi.zip

(256.97 KiB) Downloaded 205 times

[Zeeshanbhat]

Thank you very much for your help.

[STKO Team]

You're welcome