asdeasoft.net

Yes.
PFA

Thank you for your response. I tried using the adaptive time step, but I am getting this warning Screenshot 2026-06-25 182951.png . The analysis is also taking a very long time to run and is using a lot of memory. After it finishes, I get these below screenshots and it is not running the analysis ...

Thank you for your reply.

Regarding the extra cut lines, I would prefer not to add them because I want to keep the masonry brick pattern as a half-brick and full-brick arrangement model.

I also changed the value of g from 9.81 to 9810, after making this change, I am getting the error:

"ERROR: the ...

Dear STKO team,
I am trying to model an arch. My model units are in mm, and I have applied an acceleration of 0.74 g as a body force according to the required loading condition. After running the analysis, I obtained the stress and displacement/deformation results attached with this email. But I am ...

Thanks for your reply.
I followed the similar procedure you suggested, but when I merge, I’m not getting three individual solid pieces. Instead, I get a single solid, whereas I need three separate solids. Also, after merging, the geometry becomes uneven there is some opening in the geometry. so ...

Dear STKO Team,
I am trying to model an arch barrel divided into three curved regions Screenshot 2025-12-16 084741.png . When I extrude the arch I encounter an error ( Error - MpcMeshEdgeControlsVRep::buildGraphics() called without a VisualRepresentation . Additionally, when I merge the model the ...

when i did displacement control analysis for the above i got this error Target time has been reached. Current time = 0.9999999999999999
SUCCESS.
TOTAL DURATION: 1.0
======================================================================
CYCLE 1 : nsteps = 10; dU = 10.0; dT = 0.1 ...

Thank you for your response
PFA

Thank you for your response How did you calculate it?
SW = 2.5e-5 N/mm^2 - - W=22kN/m^3 converted to mm Screenshot 2025-10-09 115914.png

Did you mean i have to use Displacement control integrator: define selection set and give the dof's and target displacements Screenshot 2025-10-07 141054.png ...

I'm getting this as well src\H5AC.c line 1230 in H5AC_prep_for_file_flush(): slist enabled failed
major: Object cache
minor: Internal error detected
#008: C:\J\w\prod\BuildSingleReference\.conan\data\hdf5\1.14.0\_\_\build\f491c24a6c1b13acb3cc68e656f08b3ca13fc643\src\src\H5C.c line 2940 in H5C_set ...